How to Build a Smok Pen
The Smok Pen is a revolutionary vaporizing pen which allows for a write-to-write experience, even while you are away from home. This is because of the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. When the user wants to write, he just places the pen into the smaller tank and places the ink in the chamber where it will be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.
One of the biggest attributes of the Smok Pen is its ability to charge while it is on your desk. This is because the coils on the Smok Pen were created in a way to keep the e juice from dripping onto the table or anywhere else. This is due to the 0.3-ohm coil that’s placed inside the Smok Pen. The 0.3-ohm coil means that even the slightest of air currents won’t affect the writing process. This is because the electronic circuitry has protection built in so that it will never be affected by extremely low voltage electric currents.
The Smok Pen can be charged internally with a charger or via the USB connection that is included with it. Since the electronic circuitry includes a safety barrier built in, therefore there is absolutely no risk involved when charging these devices through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, which is ideal for all pens that use a couple of batteries.
To keep the Smok Pen working for an extended time frame it is important you don’t overcharge the battery. Overcharging the battery will reduce the voltage that is available and may eventually bring about these devices malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery is not getting the vapor it should, remove the pen from the energy source and let it cool down for some minutes.
The fire button on the Smok Pen is situated at the bottom right corner of these devices. The fire button comes with an orange light, which indicates that it’s on. You can press this button to activate the electronic heating element which will enable you to vaporize the oil. After you have done so you can take away the coil from the holder and place it in to the holder and place the Smok Pen in to the airflow chamber, that may cause the heating element to start heating up and burning off the wick.
Once the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they start to turn podsmall.com blue, that is the indication that it’s ready for the pen’s battery. Make sure that you place your sub-ohm into the chamber before you push the fire button. If you do not put the coil in to the airflow chamber then your oil will leak and cause the leaking of e-juice.
Before you put the battery in to the pen, you must make sure that you have disconnected all of the leads. Then you have to remove the Smok Pen’s cap and locate the leak or drip tip. You must clean this with a little cotton bud, so as to eliminate leak. Then reattach the cap back to the Smok Pen and you are prepared to place the battery into the pen.
The ultimate area of the construction process is the adapter plate, which fits in to the Smok Vaporizer’s USB port. This plate lets you charge your e-juice through your computer, as long as you have an adapter for USB connection. I like this part since it allows me to charge my entire kit simultaneously without worrying about running out of power or constantly running out of e-juice.